dell latitude c user s manual free pdf download november 12th linkthe dell? latitude c ez93 dell latitude c user guide owners. User guide • Read online or download PDF • Dell Latitude C User Manual • Dell Notebooks.
|Published (Last):||5 June 2015|
|PDF File Size:||8.8 Mb|
|ePub File Size:||3.91 Mb|
|Price:||Free* [*Free Regsitration Required]|
Don’t show me this message again. Laittude connectors are keyed for correct insertion; do not force the connections.
Disconnect the computer and any attached devices from electrical outlets, and remove any installed batteries.
DELL LATITUDE C SERVICE MANUAL Pdf Download.
Display Panel to Top Cover: Page 50 Microprocessor Module: The placemat provides the number of screws mnual their sizes. This manual also for: When reconnecting the display-feed flex cable connector to the system board, push down on the top left and right ends of the connector. To ensure proper thermal operation, always install a new, compatible thermal cooling assembly along with a new microprocessor.
You must remove the display assembly before you remove the palm rest. The memory module must be inserted at a degree angle to avoid damaging the connector. Dell system laptop pc system information guide c, c pages.
Reproduction in any manner whatsoever without the written permission of Dell Computer Corporation is strictly forbidden. Page 64 System Board: When removing the microprocessor module, pull the module straight up.
Disconnect the fan power cable from the system-board interface connector and remove the hybrid cooling latitufe. Memory modules are keyed, or designed to fit into their sockets, in only one direction. Remove the two M2 x 3-mm screws that are located in the hard-drive bay door labeled “circle P.
Palm Rest majual Bottom Case: Replacing the Memory Modules 1. Take note of the arrow on the ZIF-socket cam screw. Page 42 Palm Rest: Rotate the hinges forward at an angle of approximately 90 degrees to the front of the display assembly. Turn the computer over, and remove the three M2 x 3-mm screws that secure the palm rest to the bottom case: Page 51 Hybrid Cooling Fan: Carefully separate the bezel from the top cover to avoid damage to the bezel. Remove the tape that llatitude the display panel connector and the tape that secures the middle of the display-feed flex cable to the display panel.
Remove the center control cover: Replacing the Keyboard 1. You must remove the display assembly lztitude you remove the palm rest. Pressing on the center of the connector may damage resistors and compromise EMI protection in the computer. Pull the right side of the bottom case, next to the audio connectors, away from the system board as you simultaneously lift the front of the system board out and away from the bottom case.
Dell Latitude C640 User Manual
The latch will not function properly if the slider is oriented incorrectly. To release the keyboard from the palm rest, use a small, flat-blade screwdriver d540 plastic scribe to pry up the right edge of the keyboard near the blank key.
Damage due to servicing that is not authorized by Dell is not covered by your warranty. Dell Latitude C User Manual pages. Replace the M3 x 5-mm screw in the hard drive door.
If you only have one memory module, install it in the connector labeled “JDIM1” on the system board. Page 49 Microprocessor Module: Save and close any open files, exit any open programs, and then shut down latittude computer. Replace the fan guard, inserting the tab into the bottom case, and replace the three M2.
Dell Latitude C540 Service Manual
Unless otherwise noted, each procedure in this document assumes that a part can be replaced by performing the removal procedure in reverse order. By pressing ‘print’ button you will print only current page.
Computer Orientation Before You Begin: Table Of Contents System Components: