THE effect of wear and tear of the tailstock assembly of a lathe affects the accuracy of the finished product in several different ways. Wear on the bed-ways or. Assembly and Disassembly of Tailstockkiran wangikar Explain Tailstock And Its Components Lathe Machine: Production Lab MechanicalUPSC IAS. Preparing two wooden blocks (used as sleepers) and wire for guiding lead wires will be helpful. Disassemb ly and assemb ly tools. Disassembly and assembly.
|Published (Last):||4 July 2016|
|PDF File Size:||20.96 Mb|
|ePub File Size:||18.54 Mb|
|Price:||Free* [*Free Regsitration Required]|
Parts 34 and 35 appear to engage the quill somehow. Shim for dovetail segment and tailstock pads. As an apprentice I was taught that a quill extends.
They did indeed call it a spindle. You will find that LeBlond has what ever you need for your lathe. Tailstock Parts After Cleanup and Paint.
The pictures that follow are mostly taken in my garage where the forklift unloaded the machine. Dovetail ways and shims. My Uncle had a hand wheel assembly that obviously does not go to this tailstock. Login to Your Account. May want to use penetrating oil first.
I first slid the base back onto the main casting and tried to center it using the adjusting screws. I am sure there is further adjustment required here.
Tailstock | Jason’s South Bend 9 Rebuild
The hole in your part for the pin of the wrench has been damaged by folks doing it the brutal wrong way with a drift or screwdriver used as a punch. The retaining nut holding the shaft into the back of the tailstock was too large for any of my wrenches, so I got the pipe wrench out and cracked it loose. Have they been removed? Bookmarks Bookmarks Digg del. In the second photo I posted above the fourth piece to the left of the handwheel in the upper right corner of diskantling photo is that part resting on its threaded end.
Take the spindle out of the casting, and set it up on taillstock arbor press. The bottom of a tailstock is a precision component of a lathe. We have a Leadspindle and Feedspindle in our lathesand i ln not find it especially surprising some old fella called the quill a spindle, on some tailstocks it is essentially one, even though the nut revolves. Is this part obtainable from other sources or from Leblond only?
Perhaps these photos which show all the tailstock parts laid out will be helpful so you know what you’re dealing with. JohnEvansRobert Campbell An.
Finally, the locking lever and mounting bracket are reinstalled. I was lazy about taking pictures during this process, sorry, here it is fully disassembled.
Wouldn’t be as bad if he didn’t use a naughty childs profanity to puff himself up in front of an audience. I looked at the manual.
Machine Drawing by N. D. Junnarkar
Any suggestions where I can get a new one? You would know this if there’s a corresponding keyway in the quill. I applaud your asking these questions. The bronze or llathe nut which engages the screw has been severely damaged and needs to be replaced. I am starting on a 9a rebuild and just took the tailstock apart.
T he counter shaft speed control unit comes out easily in one piece. Unscrew the nut and its off. Tzilstock my machine turns out as nice as yours. I have removed the two hex screws but the nut is not free.