Honeywell RMA On-Off Primary Burner Control: Hvac Controls: : Industrial & Scientific. Find great deals for Honeywell Rm a Rev D Burner Control RMA Shop with confidence on eBay!. The RMA by Honeywell is a microprocessor based integrated primary burner control for automatically fired gas, oil or combination fuel single burner.

Author: Nezilkree Tygonris
Country: Cyprus
Language: English (Spanish)
Genre: Spiritual
Published (Last): 28 June 2012
Pages: 151
PDF File Size: 11.69 Mb
ePub File Size: 18.33 Mb
ISBN: 785-1-84233-783-5
Downloads: 40501
Price: Free* [*Free Regsitration Required]
Uploader: Shakak

Turn off more accessible mode.

Heiz24 – the Specialists in new and refurbished Controls | refurbished | Honeywell RMA NEW

Vast amounts of important information are stored in the relay module. Is this to attract attention that something is wrong? Microprocessor-based integrated primary burner control for automatically fired gas, oil or combination fuel single burner applications.

It is active in standby. This page location is: Request Our Free Catalog. Second, note hneywell the jumpers are not just wires.

Now look at Figure 3. On the RMG, there is no H. By studying Figures 2 and 3, the differences in programmers rn7890a1015 be apparent, and the most economical programmer can be selected for a specific job. On the RMA and B terminal 8, pilot, is an intermittent pilot.

  CIE S009 PDF

There are 50 HZ controls available. Clipping a jumper enhances the level of safety. With all other purge cards, 10 or more seconds; hoenywell airflow switch must close in 10 seconds. There is no powered terminal 21 on the RMA and B.

Pilot Type intermittent Vibration 0. Product Code Quantity 1 2 3 4 5. Terminal 10 is de-energized as soon as flame is proven.

RMA,RMA,Honeywell,,FSG Control Auto Primary V Primary Co,Stromquist & Company

Mechanical relays are still used, but the coils and contacts are sealed to prevent dirt, dust, grease, or any contaminant from affecting them. Note that timings for initiate, standby, purge, run, and post purge, are identical for all models.

No 4-second is available. No, the Power LED is supposed to blink every four seconds. Selectable relight or lockout on loss of flame.

Honeywell Rm7890 a 1015 Rev D Burner Control RM7890A1015

This is very important. How fast must the airflow switch contact close when using an RM? Subbase and amplifier are required for operation. Yes, order part number This takes from one to three seconds.


The switching circuit can then be used to input terminal 18 rather than jumping terminals 18 and 5, thereby avoiding 30 seconds to pre-purge timing. The only difference is that the RM includes an SA display module and the RM has only a dust cover where a display can go. This prevents continuous purge, should the airflow switch fail hoenywell.

Please contact Customer Care for assistance. Industrial Combustion Training Videos. This Info-Tec will attempt to answer some of those questions.

Author: admin